Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 690/970
11.2.1.11.2. Viewing SNTP Global Status Page
Non-Configurable Data
Version - Specifies the SNTP Version the client supports.
Supported Mode - Specifies the SNTP modes the client supports. Multiple modes may
be supported by a client.
Last Update Time - Specifies the local date and time (UTC) the SNTP client last updated
the system clock.
Last Attempt Time - Specifies the local date and time (UTC) of the last SNTP request or
receipt of an unsolicited message.
Last Attempt Status - Specifies the status of the last SNTP request or unsolicited
message for both unicast and broadcast modes. If no message has been received from a
server, a status of Other is displayed. These values are appropriate for all operational
modes.
•
OtherNone of the following enumeration values.
•
SuccessThe SNTP operation was successful and the system time was
updated.
•
Request Timed OutA directed SNTP request timed out without receiving a
response from the SNTP server.
•
Bad Date EncodedThe time provided by the SNTP server is not valid.
•
Version Not SupportedTheSNTP version supported by the server is not
compatible with the version supported by the client.
•
Server UnsychronizedThe SNTP server is not synchronized with its peers.
This is indicated via the 'leap indicator' field on the SNTP message.
•
Server Kiss Of DeathThe SNTP server indicated that no further queries were
to be sent to this server. This is indicated by a stratum field equal to 0 in a message
received from a server.
Server IP Address - Specifies the IP address of the server for the last received valid
To Next Page
Loading...