Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 838/970
IPv6 Mode - Enable IPv6 on this interface using the IPv6 address. This option is only
configurable prior to specifying an explicit IPv6 address.
IPv6 Address - Select list of configured IPv6 addresses for the selected Loopback
interface. Add is also a valid choice if the maximum number of addresses has not been
configured.
IPv6 Address - When 'Add' is chosen from the IPv6 Address selector this IPv6 address
input field becomes visible. Address must be entered in the format prefix/length.
The user also has the option to specify the 64-bit extended unique identifier (EUI-64).
IPv4 Address - The primary IPv4 address for this interface in dotted decimal notation.
IPv4 Subnet Mask - The primary IPv4 subnet mask for this interface in dotted decimal
notation.
Secondary Address - Select list of configured IPv4 secondary addresses for the selected
Loopback interface. Add Secondary is also a valid choice if the maximum number of
secondary addresses has not been configured. A primary address must be configured
before secondary addresses can be added.
Secondary IP Address - The secondary ip address for this interface in dotted decimal
notation. This input field is visible only when 'Add Secondary' is selected.
Secondary Subnet Mask - The secondary subnet mask for this interface in dotted
decimal notation. This input field is visible only when 'Add Secondary' is selected.
Command Buttons
Submit - Update the system with the values on this screen.
Delete Loopback - Remove the selected loopback interface.
Delete Primary - Remove the configured Primary IPv4 Address.
Add Secondary - Add the user specified Secondary IPv4 Address.
Delete Selected Secondary - Remove the selected Secondary IPv4 Address.
Delete Selected Address - Remove the selected IPv6 Address.
To Next Page
Loading...