Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 1093
8400 HighLine | Parameter setting & configuration
Function library
System blocks | LS_WriteParamList
Creating/changing the list
To create or change the list, proceed as follows:
1. Click on Change list button.
• The dialog box entitled Configure WriteParamList is shown:
• On the left-hand side, all the parameters of the drive controller with write and
read access are shown in the list entitled Available parameters.
• If the option In menu groups is activated, all parameters are shown assigned to
their functions.
• By clicking on the button in the Filter area, you can shorten the list of
available parameters. If, for example, you enter the text "ain1" and then click on
the button, only those parameters whose designation contains this text are
shown for selection.
2. Highlight the parameter/parameters in the Available parameters list that is/are to
be added to the WriteParamList.
• Here, you can use the <Ctrl> key and the<Shift> key for multiple selection, as in
the case of general Windows functions.
efesotomasyon.com - Lenze
To Next Page
Loading...