Lenze E84AVHC Series - Page 1094

8400 HighLine | Parameter setting & configuration
Function library
System blocks | LS_WriteParamList
1094 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
3. Click on the button in order to add the highlighted parameters to the
WriteParamList on the right-hand side.
• With the and buttons, you can alter the sequence of parameters in the
WriteParamList.
To remove parameters from the WriteParamList, proceed as follows:
• Highlight the parameter/parameters in the WriteParamList that is/are to be
removed from the WriteParamList.
• Click on the button to remove the highlighted parameters from the
WriteParamList.
4. Click on the OK button to accept the configuration and close the dialog box.
• You can call the configuration dialog again at any time in order to change or
expand the WriteParamList retrospectively.
Entering values
After composing the list, you can directly enter the desired parameter values into the input
fields (columns 1st value ... 4th value).
If you place the cursor in an input field, the permitted value range for the corresponding
parameter is shown under the table.
Copying values
All the settings of a value set can be copied to another value set.
 To copy values, proceed as follows:
1. Click on the Copy values button.
•The Copy values dialog box is displayed:
2. Select Source and Target.
3. Click on button in order to copy the values from Source to target.
efesotomasyon.com - Lenze