Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 319
8400 HighLine | Parameter setting & configuration
Technology applications
TA "Table positioning"
Port block LP_MciOut
bState_B0 LA_TabPos.bDriveFail 1 ≡ Drive controller in error status
•"Fault
" device state is active.
bState_B1 LA_TabPos.bGPSignalOut1 Binary signal monitor: Output signals 1 & 2
• The signal sources to be output are selected in C00411/
1...2.
• A bit coded inversion of the output signals can be
parameterised in C00412
.
• For a detailed functional description see
FB L_SignalMonitor_b
.
bState_B2 LA_TabPos.bGPSignalOut2
bState_B3 LA_TabPos.bCInhActive 1 ≡ Controller inhibit is active
bState_B4 LA_TabPos.bDriveReady 1 ≡ Drive controller is ready for operation
•"SwitchedON
" device state is active.
• The drive is in this device state if the DC bus voltage is
applied and the controller is still inhibited by the user
(controller inhibit).
bState_B5 LS_DigitalInput.bIn5 Signal from the digital input DI5
bState_B6 LS_DigitalInput.bIn6 Signal from the digital input DI6
bState_B7 LS_DigitalInput.bIn7 Signal from the digital input DI7
bState_B8 LA_TabPos.bInTarget 1 ≡ Target position (actual value) is in the target window
bState_B9 LA_TabPos.bProfileBusy 1 ≡ Profile positioning is active
bState_B10 LA_TabPos.bHomePosAvailable 1 ≡ Home position is known
bState_B11 LA_TabPos.bSpeedActCompare Result of the speed comparison
• In case of the "Open loop" operation:
1 ≡ Speed setpoint < comparison value (C00024
)
• For "Closed loop" operatin:
1 ≡ actual speed value < comparison value (C00024
)
bState_B12 LS_DigitalInput.bIn4 Signal from the digital input DI4
bState_B13 LS_DigitalInput.bIn3 Signal from the digital input DI3
bState_B14 LA_TabPos.bQSPIsActive 1 ≡ Quick stop is active
bState_B15 - -
wState - -
bOut2_B0 - -
...
bOut2_B15
Port Assignment Info
efesotomasyon.com - Lenze
To Next Page
Loading...