Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 49
8400 HighLine | Parameter setting & configuration
Commissioning
Commissioning the "Actuating drive speed" TA using the »Engineer«
More detailed information on the technology application:
TA "Actuating drive speed"
( 262)
Basic signal flow
( 263)
Internal interfaces | application block "LA_NCtrl"
( 265)
Control words wCANDriveControl/wMCIDriveControl
( 273)
Terminal assignment of the control modes
( 274)
Setting parameters (short overview)
( 287)
Configuration parameters (short overview)
( 289)
efesotomasyon.com - Lenze
To Next Page
Loading...