Lenze E84AVHC Series - Page 52

8400 HighLine | Parameter setting & configuration
Commissioning
Commissioning the "Table positioning" TA using the »Engineer«
52 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
6. Set the reference speed
 Change back to Application parameters tab.
 In the Reference speed input field (C00011
), enter the reference speed of the motor.
The reference speed is indicated on the motor nameplate.
7. Parameterise technology application
 Select "Table positioning" in the Application list field.
After selection of the "table positioning" application, the contents of the tab change, e.g.
only the Machine parameters and Profile entry buttons are shown.
8. Set machine parameters
 Click on the Machine parameters button in order to change to the dialog level Overview
 Machine parameters:
 Enter parameters in all fields on a yellow background, e.g. gearbox factor, feed constant
and reference speed.
efesotomasyon.com - Lenze