Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 53
8400 HighLine | Parameter setting & configuration
Commissioning
Commissioning the "Table positioning" TA using the »Engineer«
9. Change functions assigned to digital input terminals
In the constellation under consideration, a two-track encoder is connected to the DI1
terminal (track A) and DI2 terminal (track B). The functions assigned to the digital terminals
DI1 and DI2 therefore have to be reconfigured accordingly:
Go to the Terminal assignment tab.
In the list field Function assignment DI1 and DI2, set "DI1(6)&DI2(7)=FreqIn (2-track)".
– After alteration of the function assignment, the button indicated by the lower arrow
is displayed:
Click on the button indicated by the lower arrow in order to open the parameterising
dialog for the 2-track frequency input:
efesotomasyon.com - Lenze
To Next Page
Loading...