Lenze E84AVHC Series - Page 722

8400 HighLine | Parameter setting & configuration
Parameter reference
Parameter list | C00833
722 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
C00833/41 DCTRL: bStatus_B4
C00833/42 DCTRL
: bStatus_B5
C00833/43 DCTRL
: bStatus_B14
C00833/44 DCTRL
: bStatus_B15
C00833/45 DCTRL
: bFrei_1
C00833/46 DCTRL
: bFrei_2
C00833/47 DCTRL
: bFrei_3
C00833/48 DCTRL
: bFrei_4
C00833/49 L_And_2
: bIn1
C00833/50 L_And_2
: bIn2
C00833/51 L_And_2
: bIn3
C00833/52 L_And_3
: bIn1
C00833/53 L_And_3
: bIn2
C00833/54 L_And_3
: bIn3
C00833/55 L_Or_2
: bIn1
C00833/56 L_Or_2
: bIn2
C00833/57 L_Or_2
: bIn3
C00833/58 L_Or_3
: bIn1
C00833/59 L_Or_3
: bIn2
C00833/60 L_Or_3
: bIn3
C00833/61 L_Not_2
: bIn
C00833/62 L_Not_3
: bIn
C00833/63 L_DigitalLogic_1
: bIn1
C00833/64 L_DigitalLogic_1
: bIn2
C00833/65 L_DigitalLogic_1
: bIn3
C00833/66 L_DigitalDelay_1
: bIn
C00833/67 MCTRL: bPosDerivativeOn
(activate differentiation of position)
C00833/68 MCTRL
: bMotorRefOffsetOn
(accept motor reference position)
C00833/69 MCTRL
: bSpeedCtrlPAdaptOn
(Activate adaptive adjustment of the speed controller
gain)
C00833/70 L_AnalogSwitch_2
: bSet
(switch over analog values)
C00833/71 L_AnalogSwitch_3
: bSet
(switch over analog values)
C00833/72 L_MPot_1
: bUp
(ramp up)
C00833/73 L_MPot_1
: bInAct
(start inactivation function)
C00833/74 L_MPot_1
: bDown
(ramp down)
C00833/75 Reserved
C00833/76 L_PCTRL_1
: bInAct
(deactivate controller)
Parameter | Name:
C00833 | 8bit input
Data type: UNSIGNED_8
Index: 23742
d
= 5CBE
h
efesotomasyon.com - Lenze