Lenze E84AVHC Series - Page 723

Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 723
8400 HighLine | Parameter setting & configuration
Parameter reference
Parameter list | C00833
C00833/77 L_PCTRL_1: bIOff
(switch off I component of controller)
C00833/78 MCK: bSpeedCtrlIOn
(load I component of speed controller)
C00833/79 MCK: bDcBrakeOn
(activate DC-injection braking)
C00833/80 MCK: bBrkRelease
(release holding brake)
C00833/81 MCK: bBrkStartTorqueDir
(change of direction torque precontrol)
C00833/82 MCK: bBrkApplied
(feedback signal - binary holding brake status)
C00833/83 MCK: bLimitSwitchPos
(input for positive hardware limit switch)
C00833/84 MCK: bLimitSwitchNeg
(input for negative hardware limit switch)
C00833/85 MCK: bPosCtrlOn
(activate position controller)
C00833/86 MCK: bDeltaPosOn
(activate evaluation of external following error)
C00833/87 MCK: bPosDerivativeOn
(activate differentiation of position)
C00833/88 MCK: bMotorRefOffsetOn
(accept motor reference position)
C00833/89 MCK: bQspOn
(quick stop)
C00833/90 MCK: bTorquemodeOn
(activate torque control)
C00833/91 MCK: bTorqueLimitAdaptOn
(Activate adaptation of torque limitation)
C00833/92 MCK: bHomMark
(pre-stop signal - homing)
C00833/93 L_Transient_1
: bIn
C00833/94 L_Transient_2
: bIn
C00833/95 L_Transient_3
: bIn
C00833/96 L_Transient_4: bIn
C00833/97 Reserved
C00833/98 MCTRL
: bTorqueLimitAdaptOn
(Activate adaptation of torque limitation)
C00833/99 L_NSet_1
: bNAddInv
(invert additional speed setpoint)
C00833/100 L_MPot_1
: bEnable
(activate FB)
C00833/101 L_NLim_1
: bEnable
(activate FB)
C00833/102 LS_DataAccess: bEnableIn1
(Lenze internally)
C00833/103 LS_DataAccess: bEnableIn2
(Lenze internally)
Parameter | Name:
C00833 | 8bit input
Data type: UNSIGNED_8
Index: 23742
d
= 5CBE
h
efesotomasyon.com - Lenze