Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 128/970
Syntax
set igmp groupmembership-interval <1-3965> <2-3600>
no set igmp groupmembershipinterval <1-3965>
<1-3965> - VLAN ID (Range: 1 – 3965).
<2-3600> - The range of group membership interval time is 2 to 3600 seconds.
no - This command sets the IGMP Group Membership Interval time on a particular VLAN to
the default value.
Default Setting
260
Command Mode
Vlan Database
6.2.6.2.13. set igmp maxresponse
This command sets the IGMP Maximum Response time on a particular VLAN. The Maximum
Response time is the amount of time in seconds that a switch will wait after sending a query on
an interface, which is participating in the VLAN, because it did not receive a report for a
particular group in that interface. This value must be less than the IGMP Query Interval time
value.
Syntax
set igmp maxresponse <1-3965> <1-3599>
no set igmp maxresponse <1-3965>
<1-3965> - VLAN ID (Range: 1 – 3965).
no - This command sets the IGMP maximum response time on a particular VLAN to the
default value.
Default Setting
To Next Page
Loading...
Need help?
General
