Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 127/970
Syntax
ip igmp snooping static <macaddr> vlan <vlan-id> interface <slot/port>
no ip igmp snooping static <macaddr> vlan <vlan-id> interface <slot/port>
Default Setting
None
Command Mode
Global Mode
6.2.6.2.11. set igmp
This command enables IGMP snooping on a particular VLAN, and in turn enabling IGMP
snooping on all interfaces participating in this VLAN.
Syntax
set igmp <1-3965>
no set igmp <1-3965>
<1-3965> - VLAN ID (Range: 1 – 3965).
no - This command disables IGMP snooping on a particular VLAN, and in turn disabling
IGMP snooping on all interfaces participating in this VLAN.
Default Setting
None
Command Mode
Vlan Database
6.2.6.2.12. set igmp groupmembership-interval
This command sets the IGMP Group Membership Interval on a particular VLAN. The Group
Membership Interval time is the amount of time in seconds that a switch will wait for a report
from a particular group on a particular interface, which is participating in the VLAN, before
deleting the interface from the entry. This value must be greater than IGMP Maximum
Response time value. The range is 2 to 3600 seconds.
To Next Page
Loading...
Need help?
General
