Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 636/970
Telnet Server Admin Mode - Administrative mode for inbound telnet sessions. Setting
this value to disable shuts down the telnet port. If the admin mode is set to disable, then
all existing telnet connections are disconnected. The default value is Enable.
Password Threshold - When the logon attempt threshold is reached on the console port,
the system interface becomes silent for a specified amount of time before allowing the
next logon attempt. (Use the silent time command to set this interval.) When this
threshold is reached for Telnet, the Telnet logon interface closes. The default value is 3.
Command Buttons
Submit - Update the switch with the values on the screen. If you want the switch to retain
the new values across a power cycle you must perform a save.
11.2.1.3.7. Configuring Outbound Telnet Client Configuration Page
Configurable Data
Admin Mode - Specifies if the Outbound Telnet service is Enabled or Disabled. Default
value is Enabled.
Maximum Sessions - Specifies the maximum number of Outbound Telnet Sessions
allowed. Default value is 5. Valid Range is (0 to 5).
Session Timeout - Specifies the Outbound Telnet login inactivity timeout. Default value
is 5. Valid Range is (1 to 160).
Command Buttons
Submit - Sends the updated configuration to the switch. Configuration changes take
effect immediately.
To Next Page
Loading...
Need help?
General
