Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 692/970
Unicast SNTP requests will be sent to this address. If this address is a DNS hostname,
then that hostname should be resolved into an IP address each time a SNTP request is
sent to it.
Address Type - Specifies the address type of the configured SNTP Server address.
Allowed types are :
•
Unknown
•
IPV4
•
DNS
Default value is Unknown
Port - Specifies the port on the server to which SNTP requests are to be sent. Allowed
range is (1 to 65535). Default value is 123.
Priority - Specifies the priority of this server entry in determining the sequence of servers
to which SNTP requests will be sent. The client continues sending requests to different
servers until a successful response is received or all servers are exhausted. This object
indicates the order in which to query the servers. A server entry with a precedence of 1
will be queried before a server with a priority of 2, and so forth. If more than one server
has the same priority then the requesting order will follow the lexicographical ordering of
the entries in this table. Allowed range is (1 to 3). Default value is 1.
Version - Specifies the NTP Version running on the server. Allowed range is (1 to 4).
Default value is 4.
Command Buttons
Submit - Sends the updated configuration to the switch. Configuration changes take
effect immediately.
Delete - Deletes the SNTP Server entry. Sends the updated configuration to the switch.
Configuration changes take effect immediately.
To Next Page
Loading...
Need help?
General
