Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 721/970
Submit - Update the switch with the values you entered. If you want the switch to retain
the new values across a power cycle you must perform a save. You will only see this
button if you have Read/Write access privileges.
11.2.2.11.2. Defining IGMP Snooping Interface Configuration Page
Configurable Data
Slot/Port - The single select box lists all physical ,VLAN and LAG interfaces. Select the
interface you want to configure.
Admin Mode - Select the interface mode for the selected interface for IGMP Snooping
for the switch from the pulldown menu. The default is disable.
Group Membership Interval - Specify the amount of time you want the switch to wait for
a report for a particular group on a particular interface before it deletes that interface from
the group. Enter a value between 1 and 3600 seconds. The default is 260 seconds.
Max Response Time - Specify the amount of time you want the switch to wait after
sending a query on an interface because it did not receive a report for a particular group
on that interface. Enter a value greater or equal to 1 and less than the Group Membership
Interval in seconds. The default is 10 seconds. The configured value must be less than
the Group Membership Interval.
To Next Page
Loading...
Need help?
General
