Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 740/970
Snooping Querier Address - Specify the Snooping Querier Address to be used as
source address in periodic MLD queries. This address is used when no address is
configured on the VLAN on which query is being sent.
MLD Version - Specify the MLD protocol version used in periodic MLD queries. MLD
queries.
Query Interval - Specify the time interval in seconds between periodic queries sent by
the snooping querier. The Query Interval must be a value in the range of 1 and 1800. The
default value is 60.
Querier Expiry Interval - Specify the time interval in seconds after which the last querier
information is removed. The Querier Expiry Interval must be a value in the range of 60
and 300. The default value is 60.
Configurable Data
Submit - Update the switch with the configured values.
Refresh - Reload the information on the page.
11.2.2.14.2. Configuring MLD Snooping VLAN Configuration Page
Selection Criteria
VLAN ID - Selects the VLAN ID on which MLD Snooping Querier is enabled.
Configurable Data
VLAN ID - Appears when "New Entry" is selected in VLAN ID selection list. Specifies
VLAN ID for which MLD Snooping Querier is to be enabled. User can also set
pre-configurable Snooping Querier parameters.
Querier Election Participate Mode - Enable or disable the Igmp Snooping Querier
participate in election mode. When this mode is disabled, up on seeing other querier of
To Next Page
Loading...
Need help?
General
