Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 790/970
Always - Sets the router advertise 0.0.0.0/0.0.0.0 when set to "True".
Metric - Specifies the metric of the default route. The valid values are (0 to 16777215)
Metric Type - Sets the metric type of the default route.
Non-Configurable Data
ASBR Mode - Reflects whether the ASBR mode is enabled or disabled. Enable implies
that the router is an autonomous system border router. Router automatically becomes an
ASBR when it is configured to redistribute routes learnt from other protocol.
ABR Status - The values of this are enabled or disabled. Enabled implies that the router
is an area border router. Disabled implies that it is not an area border router.
External LSA Count - The number of external (LS type 5) LSAs (link state
advertisements) in the link state database.
External LSA Checksum - The sum of the LS checksums of the external LSAs (link
state advertisements) contained in the link-state database. This sum can be used to
determine if there has been a change in a router's link state database, and to compare
the link-state databases of two routers.
New LSAs Originated - In any given OSPF area, a router will originate several LSAs.
Each router originates a router-LSA. If the router is also the Designated Router for any of
the area's networks, it will originate network-LSAs for those networks. This value
represents the number of LSAs originated by this router.
LSAs Received - The number of LSAs (link state advertisements) received that were
determined to be new instantiations. This number does not include newer instantiations
of self-originated LSAs.
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is
performed.
To Next Page
Loading...