Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 799/970
Backup Designated Router - The identity of the Backup Designated Router for this
network, in the view of the advertising router. The Backup Designated Router is identified
here by its router ID. Set to 0.0.0.0 if there is no Backup Designated Router. This field is
only displayed if the OSPF admin mode is enabled.
Number of Link Events - This is the number of times the specified OSPF interface has
changed its state. This field is only displayed if the OSPF admin mode is enabled.
Command Buttons
Configure Authentication - Display a new screen where you can select the
authentication method for the virtual link.
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is
performed.
11.2.3.3.7. Viewing Neighbor Table Information
This panel displays the OSPF neighbor table list. When a particular neighbor ID is specified,
detailed information about a neighbor is given. The information below will only be displayed if
To Next Page
Loading...