Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 816/970
immediately. These changes will not be retained across a power cycle unless a save is
performed.
11.2.3.6.2. Viewing Each Routing Interface’s RIP Configuration Page
Non-Configurable Data
Slot/Port - The slot and port for which the information is being displayed.
IP Address - The IP Address of the router interface.
Send Version - The RIP version to which RIP control packets sent from the interface
conform. The value is one of the following:
RIP-1 - RIP version 1 packets will be sent using broadcast.
RIP-1c - RIP version 1 compatibility mode. RIP version 2 formatted packets will be
transmitted using broadcast.
RIP-2 - RIP version 2 packets will be sent using multicast.
None - RIP control packets will not be transmitted.
The default is RIP-2.
Receive Version - Which RIP version control packets will be accepted by the interface.
The value is one of the following:
RIP-1 - only RIP version 1 formatted packets will be received.
RIP-2 - only RIP version 2 formatted packets will be received.
Both - packets will be received in either format.
None - no RIP control packets will be received.
The default is Both.
RIP Admin Mode - Whether RIP is enabled or disabled on the interface.
Link State - Whether the RIP interface is up or down.
Command Buttons
To Next Page
Loading...
Need help?
General
