Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 913/970
Source Prefix / PrefixLength - Specify IPv6 Prefix combined with IPv6 Prefix length of
the network or host from which the packet is being sent. Prefix length can be in the range
(0 to 128).
Source L4 Port - Specify a packet's source layer 4 port as a match condition for the
selected IPv6 ACL rule. Source port information is optional. Source port information can
be specified in two ways:
Select keyword "other" from the drop down menu and specify the number of the port
in the range from 0 to 65535.
Select one of the keyword from the list: DOMAIN, ECHO, FTP, FTPDATA, HTTP,
SMTP, SNMP, TELNET, TFTP, and WWW. Each of these values translates into its
equivalent port number, which is used as both the start and end of the port range.
Destination Prefix / PrefixLength - Enter up to 128-bit prefix combined with prefix length
to be compared to a packet's destination IP Address as a match criteria for the selected
IPv6 ACL rule. Prefix length can be in the range (0 to 128).
Destination L4 Port Keyword - Specify the destination layer 4 port match conditions for
the selected IPv6 ACL rule. The possible values are DOMAIN, ECHO, FTP, FTPDATA,
HTTP, SMTP, SNMP, TELNET, TFTP, and WWW. Each of these values translates into its
equivalent port number, which is used as both the start and end of the port range. This is
an optional configuration.
Destination L4 Port Number - Specify a packet's destination layer 4 port number match
condition for the selected IPv6 ACL rule. This is an optional configuration.
Flow Label - Flow label is 20-bit number that is unique to an IPv6 packet, used by end
stations to signify quality-of-service handling in routers. Flow label can specified within the
range (0 to 1048575).
IPv6 DSCP Service - Specify the IP DiffServ Code Point (DSCP) field.The DSCP is
defined as the high-order six bits of the Service Type octet in the IPv6 header. This is an
optional configuration. Enter an integer from 0 to 63. The IPv6 DSCP is selected by
possibly selection one of the DSCP keyword from a dropdown box. If a value is to be
selected by specifying its numeric value, then select the 'Other' option in the dropdown
box and a text box will appear where the numeric value of the DSCP can be entered.
Command Buttons
Configure - Configure the corresponding match criteria for the selected rule.
Delete - Remove the currently selected Rule from the selected ACL. These changes will
not be retained across a power cycle unless a save configuration is performed.
To Next Page
Loading...