Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 967/970
11.2.7.6.4. Viewing Interface’s PIM-SM Configuration Page
Selection Criteria
Slot/Port - Select the slot and port for which data is to be displayed. Slot 0 is the base unit.
Non-Configurable Data
Mode - The administrative status of PIM-SM in the router: either enable or disable.
Protocol State - The operational state of the PIM-SM protocol on this interface.
IP Address - The IP address of the selected PIM interface.
Net Mask - The network mask for the IP address of the selected PIM interface.
Designated Router - The Designated Router on the selected PIM interface. For point-to-
point interfaces, this object has the value 0.0.0.0.
Hello Interval (secs) - The frequency at which PIM Hello messages are transmitted on
the selected interface.
CBSR Preference - The preference value for the local interface as a candidate bootstrap
router. The value of -1 is used to indicate that the local interface is not a candidate BSR
interface.
CBSR Hash Mask Length - The CBSR hash mask length to be advertised in bootstrap
messages if this interface is elected as the bootstrap router. This hash mask length will be
used in the hash algorithm for selecting the RP for a particular group.
CRP Preference - The preference value for the local interface as a candidate bootstrap
router. The value of -1 is used to indicate that the local interface is not a candidate BSR
interface.
Neighbor Count - The number of PIM neighbors on the selected interface.
IP Address - The IP address of the PIM neighbor for this entry.
Up Time - The time since this PIM neighbor (last) became a neighbor of the local router.
Expiry Time - The minimum time remaining before this PIM neighbor will be aged out.
Command Buttons
Refresh - Refresh the data on the screen with the present state of the data in the router.
To Next Page
Loading...