Lenze E84AVHC Series - Page 1104

8400 HighLine | Parameter setting & configuration
Index
1104 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
Comparing interconnections 867
Comparison L_Counter 1-3 (C01101) 763
Comparison value N_Act (C00024) 595
Config. group error (C00148) 613
Configuration of AutoFailReset (C00188) 626
Configuring exception handling of the CAN PDOs 528
Configuring exception handling of the output
terminals
244
Connect. table 16-bit AdditionalFBsHL (C613) 677
Connect. table 32-bit AdditionalFBsHL (C617) 677
Connect. table Bool AdditionalFBsHL (C615) 677
Consumer heartbeat time (I-1016) 555
Control word (MCK) 369
Controller commands (C00002) 585
Conventions used 22
Conventions used for variable identifiers 825
Copying a complete interconnection 870
Copying an FB interconnection 870
Copying an interconnection 870
Copying elements 861
Copying interconnection elements 861
Copying objects 861
Counter Receive Error Isr (C297) 635
CountInx
Counter content (C02841)
795
Parameter (C02840) 795
CRC error 542
Current AutoFailReset procedures (C00187) 626
Current error (C00170) 623
Current limit values (C726) 702
Current limits, defining 109
Current setpoint filter (band-stop filter) 160
Current switching frequency (C00725) 701
D
Data type 580
Data type entry 825
DCB
Current (C00036)
596
Hold time (C00107) 606
DCB (DC-injection braking) 175
DC-bus voltage (C00053) 598
DC-injection braking 174
Debug address (C306) 635
Debug information (C320) 636
Debug value (C307) 635
DebugAccess (C301) 635
Decel. time - add. setpoint (C00221) 628
Decel. time - main setpoint (C00013) 592
Deceleration time - quick stop (C00105) 606
Decoupling
AnalogOut (C00441)
656
DigOut (C00447) 659
Defining a user-defined V/f characteristic 123
Delayed resp. to fault
DC-bus overvoltage (C00601)
675
Device overload monitoring (Ixt) 198
Device state (C00137) 611
Device states (LED status display) 454
Device type (I-1000) 551
Device utilisat. threshold (Ixt) (C00123) 608
Device utilisation (Ixt) (C00064) 599
dF18
BU RCOM error (error message)
490
dF21
BU watchdog (error message)
490
dF22
CU watchdog (error message)
490
dF25
CU RCOM error (error message)
490
dF35
AutoTrip reset (error message)
490
dF50
Retain error (error message)
490
dH09
EEPROM power section (error message)
493
dH10
Fan failure (error message)
493
dH69
Adjustment fault (error message)
493
DI 1/2 & 6/7
Function (C00115)
607
Diagnostics X6
Changing the baud rate (C01903)
789
Current baud rate (C01905) 789
max. baud rate (C01902) 788
Digital input assignment 694
Digital inputs 217
Digital outputs 231
DigOut
Decoupling value (C00448)
660
DIP switch settings 505
DIx
Debounce time (C02830)
794
Level (C00443) 657
Polarity (C00114) 607
DOx
Delay times (C00423)
653
Inversion (C00118) 608
Level (C00444) 658
DRIVE ERROR (LED) 454
DRIVE ERROR-LED 454
Drive interface 65
DRIVE READY (LED) 454
DRIVE READY-LED 454
efesotomasyon.com - Lenze