Lenze E84AVHC Series - Page 1112

8400 HighLine | Parameter setting & configuration
Index
1112 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
Motor control 96
Motor cosine phi (C00091) 604
Motor current (C00054) 598
Motor data 97
Motor holding brake 437
Motor load monitoring (I2xt) 199
Motor magnetising current (C00095) 604
Motor magnetising inductance (C00092) 604
Motor overload threshold (I²xt) (C00120) 608
Motor parameter identification 102
Motor parameter identification is active 79
Motor phase failure monitoring 204
Motor phase failure threshold (C00599) 675
Motor phases
Direction of rotation (C00905)
750
Motor rotor resistance (C00082) 602
Motor rotor time constant (C00083) 603
Motor selection 97
Motor stator leakage inductance (C00085) 603
Motor stator resistance (C00084) 603
Motor temperature monitoring (PTC) 201
Motor voltage (C00052) 598
N
Nact filter time constant (C00497) 666
Network management telegram (NMT) 514
NMT (network management) 514
Node address 510
Node ID 510
Number of encoder increments (C00420) 652
O
OC1
Power section - short circuit (error message)
480
OC10
Maximum current reached (error message)
481
OC11
Clamp operation active (error message)
482
OC12
I2xt overload - brake resistor (error message)
482
OC13
Maximum current for Fch exceeded (error message)
483
OC14
Direct-axis current controller limitation (error
message)
483
OC15
Cross current controller limitation (error message)
484
OC16
Torque controller limitation (error message)
484
OC17
Clamp sets pulse inhibit (error message)
481
OC2
Power section - earth fault (error message)
481
OC5
Ixt overload (error message)
479
OC6
I2xt overload - motor (error message)
484
OH1
Heatsink overtemperature (error message)
479
OH3
Motor temperature (X106) triggered (error
message)
479
OH4
Heatsink temp. > shutdown temp. -5°C (error
message)
479
Open-circuit monitoring, encoder 207
Operating conditions (CAN on board) 502
Operating mode 105
Homing 395
Manual jog 406
Position follower 431
Positioning 414
Speed follower 393
Stop 430
Operating mode change with profile number 382
Operation with safety module 373
Optimising the response to setpoint changes (SC) 158
Optimising the response to setpoint changes (SLVC)
142
Original application|Control source (C00008) 589
OS1
Maximum speed limit reached (error message)
481
Oscill. damping - field weakening (C00236) 630
Oscillation damping 180
Oscillation damping influence (C00234) 630
OT1
Maximum torque reached (error message)
479
OT2
Speed controller output limited (error message)
483
OU
DC bus overvoltage (error message)
480
Output frequency (C00058) 598
Overchange 420
Override 433
Override point of field weakening (C00080) 602
OxI
Current (C00437)
654
OxU
Voltage (C00436)
654
OxU/I
Gain (C00434)
654
Input value (C00439) 655
Offset (C00435) 654
P
Parameterisable function blocks 823
PartitionOffset (C308) 635
PartitionSel (C309) 636
efesotomasyon.com - Lenze