Nexus
MPC5566 Microcontroller Reference Manual, Rev. 2
25-10 Freescale Semiconductor
25.4 NDI Functional Description
25.4.1 Enabling Nexus Clients for TAP Access
After the NDI is out of the reset state, the loading of a specific instruction in the JTAG controller (JTAGC)
block is required to grant the NDI ownership of the TAP. Each Nexus client has its own JTAGC instruction
opcode for ownership of the TAP, granting that client the means to read/write its registers. The JTAGC
instruction opcode for each Nexus client is shown in Table 25-4. After the JTAGC opcode for a client has
been loaded, the client is enabled by loading its NEXUS-ENABLE instruction. The NEXUS-ENABLE
instruction opcode for each Nexus client is listed in Table 25-5. Opcodes for all other instructions
supported by Nexus clients can be found in the relevant sections of this chapter.
001 0011–001 1111 Reserved
010 0000 Instruction Address Compare 1 (IAC1)
010 0001 Instruction Address Compare 2 (IAC2)
010 0010 Instruction Address Compare 3 (IAC3)
010 0011 Instruction Address Compare 4 (IAC4)
010 0100 Data Address Compare 1 (DAC1)
010 0101 Data Address Compare 2 (DAC2)
010 0110–010 1011 Reserved
010 1100 Debug Counter Register (DBCNT)
010 1101 Debug PCFIFO (PCFIFO) (read-only)
010 1110–010 1111 Reserved
011 0000 Debug Status Register (DBSR)
011 0001 Debug Control Register 0 (DBCR0)
011 0010 Debug control register 1 (DBCR1)
011 0011 Debug control register 2 (DBCR2)
011 0100 Debug control register 3 (DBCR3)
011 0101–101 1111 Reserved (do not access)
111 0000–111 1011 General purpose register selects [0:11]
111 1100 Nexus3-access
111 1101 LSRL select
111 1110 Enable_OnCE (and bypass)
111 1111 Bypass
Table 25-3. e200z6 OnCE Register Addressing (continued)
OCMD, RS[0:6] Register Selected
To Next Page
Loading...
