Signal Description
MPC5566 Microcontroller Reference Manual, Rev. 2
Freescale Semiconductor 2-31
2.3.8.6 Analog Input / Differential Analog Input
AN[5]_DAN2–
AN[5] is a single-ended analog input to the two on-chip ADCs. DAN2– is the negative terminal of the
differential analog input DAN2 (DAN2+ to DAN2–).
2.3.8.7 Analog Input / Differential Analog Input
AN[6]_DAN3+
AN[6] is a single-ended analog input to the two on-chip ADCs. DAN3+ is the positive terminal of the
differential analog input DAN3 (DAN3+ to DAN3–).
2.3.8.8 Analog Input / Differential Analog Input
AN[7]_DAN3–
AN[7] is a single-ended analog input to the two on-chip ADCs. DAN3– is the negative terminal of the
differential analog input DAN3 (DAN3+ to DAN3–).
2.3.8.9 Analog Input / Multiplexed Analog Input
AN[8]_ANW
AN[8] is an analog input pin. ANW is an analog input in external multiplexed mode.
2.3.8.10 Analog Input / Multiplexed Analog Input
AN[9]_ANX
AN[9] is an analog input pin. ANX is an analog input in external multiplexed mode.
2.3.8.11 Analog Input / Multiplexed Analog Input
AN[10]_ANY
AN[10] is an analog input pin. ANY is an analog input in external multiplexed mode.
2.3.8.12 Analog Input / Multiplexed Analog Input
AN[11]_ANZ
AN[11] is an analog input pin. ANZ is an analog input in external multiplexed mode.
NOTE
Attempts to convert the input voltage applied to AN[12], AN[13], AN[14],
and AN[15] while a non-eQADC function is selected causes an undefined
conversion result.
To Next Page
Loading...
