EasyManua.ls Logo

NXP Semiconductors MPC5566 - Multi-Master Operation Memory Map

NXP Semiconductors MPC5566
1268 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Introduction
MPC5566 Microcontroller Reference Manual, Rev. 2
1-22 Freescale Semiconductor
1.7 Multi-Master Operation Memory Map
When the MCU acts as a slave in a multi-master system, the external bus interface (EBI) translates the
24-bit external address to a 32-bit internal address. Table 1-3 lists the translation parameters.
0xFFFC_0000–0xFFFC_3FFF 16 KB 1152 Controller area network (FlexCAN A)
0xFFFC_4000–0xFFFC_7FFF 16 KB 1152 Controller area network (FlexCAN B)
0xFFFC_8000–0xFFFC_BFFF 16 KB 1152 Controller area network (FlexCAN C)
0xFFFC_C000–0xFFFC_FFFF 16 KB 1152 Controller area network (FlexCAN D)
0xFFFD_0000–0xFFFF_BFFF 176 KB N/A Reserved
0xFFFF_C000–0xFFFF_FFFF
4
16 KB 16 KB
Boot assist module (BAM)
4
1
If the allocated size is more than the used size, the base address for the module is the lowest address of the listed address range,
unless noted otherwise.
2
A common configuration is: EBI memory ranges from 0x2000_0000 to 0x2FFF_FFFF; and Calibration memory ranges from
0x3000_0000 to 0x3FFF_FFFF. Hardware does not force any restrictions on allocating memory to the EBI versus calibration bus.
3
The FEC pins are muxed with DATA[16:31].
4
The BAM address range is configured so that the 4 KB BAM occupies 0xFFFF_F000–0xFFFF_FFFF.
Table 1-3. External to Internal Memory Map Translation Table for Slave Mode
External Address[8:11]
1
1
Only the lower 24 address signals (ADDR[8:31]) are available off-chip for external master accesses.
Internal Address[0:11] MB Internal Slave Internal Address Range
0b0xxx N/A 8 N/A N/A. Off-chip flash access
0b10xx 0b0000_0000_00xx 4 Internal flash array 0x0000_0000–0x003F_FFFF
0b1100 0b0100_0000_0000 1 Internal SRAM 0x4000_0000–0x4000_FFFF
0b1101 0b0110_0000_0000 1 Reserved
2
2
Reserved for a future module that requires its own crossbar slave port.
0x6000_0000–0x600F_FFFF
0b1110 0b1100_0011_1111 1 Bridge A peripherals 0xC3F0_0000–0xC3FF_FFFF
0b1111 0b1111_1111_1111 1 Bridge B peripherals 0xFFF0_0000–0xFFFF_FFFF
Table 1-2. MPC5566 Detailed Memory Map (continued)
Address Range
1
Allocated Size
1
(bytes)
Used Size
(bytes)
Use

Table of Contents

Related product manuals