NXP Semiconductors MPC5566 - Pad Configuration Register 126 (SIU_PCR126)

System Integration Unit (SIU)
MPC5566 Microcontroller Reference Manual, Rev. 2
Freescale Semiconductor 6-69
Refer to Table 6-19 for bit field definitions. Table 6-85 lists the PA fields for
ETPUA[11]_ETPUA[23]_GPIO[125].
6.3.1.86 Pad Configuration Register 126 (SIU_PCR126)
The SIU_PCR126 register controls the function, direction, and electrical attributes of
ETPUA[12]_PCSB[1]_GPIO[126].
Figure 6-87. ETPUA[12]_PCSB[1]_GPIO[126] Pad Configuration Register (SIU_PCR126)
Refer to Table 6-19 for bit field definitions. Table 6-86 lists the PA fields for
ETPUA[12]_PCSB[1]_GPIO[126].
Table 6-85. PCR125 PA Field Definitions
PA Field Pin Function
0b00 GPIO[125]
0b01 ETPUA[11]
0b10 ETPUA[23]
0b11 ETPUA[11]
Address: Base + 0x013C Access: R/W
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
R 0 0 0 0
PA OBE
1
1
When configured as PCSB[1], the OBE bit has no effect. The OBE bit must be set to 1 for ETPUA[12] or GPIO[126] when
configured as outputs.
IBE
2
2
The IBE bit must be set to 1 for ETPUA[12] or GPIO[126] when configured as inputs. When the pad is configured as an output,
set the IBE bit to 1 to show the pin state in the GPDI register.
0 0
ODE HYS SRC WPE WPS
W
RESET: 0 0 0 0 0 0 0 0 0 0 0 0 0 0 1 U
3
3
The weak pullup/down selection at reset for the ETPUA[12] and PCSB[1] pin is determined by the WKPCFG pin.
Table 6-86. PCR126 PA Field Definitions
PA Field Pin Function
0b00 GPIO[126]
0b01 ETPUA[12]
0b10 PCSB[1]
0b11 ETPUA[12]