NXP Semiconductors MPC5566 - Pcsb[4]_Sckc_Gpio[109; Pcsb[5]_Pcsc[0]_Gpio[110

Signal Description
MPC5566 Microcontroller Reference Manual, Rev. 2
2-30 Freescale Semiconductor
2.3.7.17 DSPI B / DSPI C Clock / GPIO
PCSB[4]_SCKC_GPIO[109]
PCSB[4]_SCKC_GPIO[109] — PCSB[4] is the primary function and is a peripheral chip select output pin
for the DSPI B module. SCKC is the alternate function and is the SPI clock for the DSPI C module.
2.3.7.18 DSPI B / DSPI C / GPIO
PCSB[5]_PCSC[0]_GPIO[110]
PCSB[5]_PCSC[0]_GPIO[110] — PCSB[5] is the primary function and is a peripheral chip select output
pin for the DSPI B module. PCSC[0] is the alternate function and is a DSPI C peripheral chip select output,
but can also be used as a Slave Select (SS) input pin for DSPI C module slave mode operation.
2.3.8 Enhanced Queued A/D Controller (eQADC) Signals
2.3.8.1 Analog Input / Differential Analog Input
AN[0]_DAN0+
AN[0] is a single-ended analog input to the two on-chip ADCs. DAN0+ is the positive terminal of the
differential analog input DAN0 (DAN0+ to DAN0–).
2.3.8.2 Analog Input / Differential Analog Input
AN[1]_DAN0–
AN[1] is a single-ended analog input to the two on-chip ADCs. DAN0– is the negative terminal of the
differential analog input DAN0 (DAN0+ to DAN0–).
2.3.8.3 Analog Input / Differential Analog Input
AN[2]_DAN1+
AN[2] is a single-ended analog input to the two on-chip ADCs. DAN1+ is the positive terminal of the
differential analog input DAN1 (DAN1+ to DAN1–).
2.3.8.4 Analog Input / Differential Analog Input
AN[3]_DAN1–
AN[3] is a single-ended analog input to the two on-chip ADCs. DAN1– is the negative terminal of the
differential analog input DAN1 (DAN1+ to DAN1–).
2.3.8.5 Analog Input / Differential Analog Input
AN[4]_DAN2+
AN[4] is a single-ended analog input to the two on-chip ADCs. DAN2+ is the positive terminal of the
differential analog input DAN2 (DAN2+ to DAN2–).