NXP Semiconductors MPC5566 - Page 902

Enhanced Queued Analog-to-Digital Converter (eQADC)
MPC5566 Microcontroller Reference Manual, Rev. 2
Freescale Semiconductor 19-99
Table 19-55 describes a list of methods to generate eDMA requests by the eQADC.
Table 19-54. eQADC FIFO Interrupt Summary
1
1
For details refer to Section 19.3.2.8, “eQADC FIFO and Interrupt Status Registers 0–5 (EQADC_FISRn),” and
Section 19.3.2.7, “eQADC Interrupt and eDMA Control Registers 0–5 (EQADC_IDCRn).”
Interrupt Condition Clearing Mechanism
Non Coherency Interrupt NCIEn = 1
NCFn = 1
Clear NCFn bit by writing a 1 to the bit.
Trigger Overrun Interrupt
2
TORIEn = 1
TORFn =1
Clear TORFn bit by writing a 1 to the bit.
Pause Interrupt PIEn = 1
PFn =1
Clear PFn bit by writing a 1 to the bit.
End of Queue Interrupt EOQIEn = 1
EOQFn = 1
Clear EOQFn bit by writing a 1 to the bit.
Command FIFO Underflow Interrupt
2
CFUIEn = 1
CFUFn = 1
Clear CFUFn bit by writing a 1 to the bit.
Command FIFO Fill Interrupt CFFEn = 1
CFFSn = 0
CFFFn = 1
Clear CFFFn bit by writing a 1 to the bit.
Result FIFO Overflow Interrupt
2
2
Apart from generating an independent interrupt request for when a RFIFO overflow interrupt, a CFIFO underflow
interrupt, and a CFIFO trigger overrun interrupt occurs, the eQADC also provides a combined interrupt request at
which these requests from ALL CFIFOs are ORed. Refer to Figure 19-54 for details.
RFOIEn = 1
RFOFn = 1
Clear RFOFn bit by writing a 1 to the bit.
Result FIFO Drain Interrupt RFDEn = 1
RFDSn = 0
RFDFn = 1
Clear RFDFn bit by writing a 1 to the bit.
Table 19-55. eQADC FIFO eDMA Summary
1
1
For details refer to Section 19.3.2.8, “eQADC FIFO and Interrupt Status Registers 0–5 (EQADC_FISRn),” and
Section 19.3.2.7, “eQADC Interrupt and eDMA Control Registers 0–5 (EQADC_IDCRn).”
eDMA Request Condition Clearing Mechanism
Result FIFO Drain
eDMA Request
RFDEn = 1
RFDSn = 1
RFDFn = 1
The eQADC automatically clears the RFDFn when RFIFOn becomes
empty. Writing 1 to the RFDFn bit is not allowed while RDFS = 1.
Command FIFO Fill
eDMA Request
CFFEn = 1
CFFSn = 1
CFFFn = 1
The eQADC automatically clears the CFFFn when CFIFOn becomes
full. Writing 1 to the CFFFn bit is not allowed while CFDS = 1.