RUGGEDCOM ROX II
User Guide
Chapter 3
Device Management
Adding a Repository 73
Parameter Description
app-name The name of a configured app repository as it appears in the repository configuration. To
check more than one repository, use a comma-separated list.
3. On the Trigger Action form, click Perform. The connection results are displayed.
Section 3.12.5.3
Adding a Repository
To add an application repository, do the following:
NOTE
An application repository must be configured before an application can be installed or upgraded.
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to admin » software-upgrade » apps » repository and click <Add repository>. The Key
Settings form appears.
Figure 71: Key Settings Form
1. App Name Box 2. Add Button
3. Configure the following parameter(s) as required:
Parameter Description
app-name The name of the app to upgrade or install. This name must be accurate. Consult the
release notes for the app.
4. Click Add to create the repository connection. The Repository form appears.
To Next Page
Loading...
