RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Viewing a List of Static MAC Addresses 691
Section 5.33.4.1
Viewing a List of Static MAC Addresses
To view a list of static MAC addresses configured on the device, navigate to switch » mac-tables » static-mac-
table. If static MAC addresses have been configured, the Static MAC Address Parameters table appears.
Figure 812: Static MAC Address Parameters Table
If no static MAC addresses have been configured, add addreses as needed. For more information, refer to
Section 5.33.4.2, “Adding a Static MAC Address”.
Section 5.33.4.2
Adding a Static MAC Address
To add a static MAC address, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to switch » mac-tables » static-mac-table and click <Add static-mac>. The Key Settings form
appears.
Figure 813: Key Settings Form
1. MAC Address Box 2. VLAN ID Box 3. Add Button
3. Configure the following parameter(s) as required:
To Next Page
Loading...
