Siemens RX1500

Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
602 Managing Link Failover Parameters
1
2
3
4
5
6
Figure 702: Link Fail Over Status Form
1. Main Link Status 2. Backup Link Status 3. Main Ping Test 4. Time of Last State Change 5. Link Backup State 6. Backup
Interface in Use
This form provides the following information:
Parameter Description
main-link-status The main link status.
backup-link-status The backup link status.
main-ping-test The results of pinging the target using the main interface.
time-of-last-state-change The time of the last state change.
link-backup-state The backup link state.
backup-interface-in-use The name of the backup interface that is being used.
Section 5.27.3
Managing Link Failover Parameters
The following sections describe how to configure and manage parameters for link failover protection:
• Section 5.27.3.1, “Viewing a List of Link Failover Parameters”
• Section 5.27.3.2, “Adding a Link Failover Parameter”
• Section 5.27.3.3, “Deleting a Link Failover Parameter”