RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Viewing a List of Route Map Filter Entries 521
Figure 598: Route Map Table
If no filters have been configured, add filters as needed. For more information, refer to Section 5.21.6.3, “Adding
a Route Map Filter”.
Section 5.21.6.2
Viewing a List of Route Map Filter Entries
To view a list of entries for a route map filter for either OSPF, navigate to routing » dynamic » ospf » filter »
route-map » {tag} » entry, where {tag} is the tag for the route map filter. If entries have been configured, the
Route Map Entry table appears.
Figure 599: Route Map Entry Table
If no filters have been configured, add filters as needed. For more information, refer to Section 5.21.6.4, “Adding
a Route Map Filter Entry”.
Section 5.21.6.3
Adding a Route Map Filter
To add a route map filter for dynamic OSPF routes, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » ospf » filter » route-map and click <Add route-map>. The Key Settings
form appears.
To Next Page
Loading...
