Chapter 3
Device Management
RUGGEDCOM ROX II
User Guide
132 Viewing a List of Remote Hosts
• Section 3.21.11.3, “Deleting a Remote Host”
Section 3.21.11.1
Viewing a List of Remote Hosts
To view a list of remote hosts configured for a serial port using the raw socket protocol, navigate to interface »
serial » {slot/port} » protocols » rawsocket » setrawsocket » remote-host, where {slot/port} is the slot name
and port number of the serial port. If remote hosts have been configured, the Remote Host Configuration table
appears.
Figure 132: Remote Host Configuration Table
If no remote hosts have been configured, add hosts as needed. For more information, refer to Section 3.21.11.2,
“Adding a Remote Host”.
Section 3.21.11.2
Adding a Remote Host
To add a remote host for a serial port using the raw socket protocol, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to interface » serial » {slot/port} » protocols » rawsocket » setrawsocket » remote-host,
where {slot/port} is the slot name and port number of the serial port.
3. Click <Add remote-host>. The Key Settings form appears.
Figure 133: Key Settings Form
1. Remote IP Box 2. Remote Port Box 3. Add Button
To Next Page
Loading...
