Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
418 Configuring an Interface
Interfaces are added automatically when a VLAN is created. For more information about creating a VLAN, refer to
Section 5.35, “Managing VLANs”.
Section 5.18.5.2
Configuring an Interface
By default, two interfaces are already configured for IS-IS: fe-cm-01 and switch.0001.
To configure optional parameters for these and any other interfaces that have been added for IS-IS, do the
following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » isis » interface and select an interface. The Interface Parameters form
appears.
To Next Page
Loading...
