RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Deleting a Remote Daemon 653
Section 5.29.6.3
Deleting a Remote Daemon
To delete a remote daemon, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to tunnel » l2tunneld » goose » {name} » remote-daemon, where {name} is the name of the
GOOSE tunnel. The Remote Daemon of Goose Tunnel table appears.
Figure 767: Remote Daemon of Goose Tunnel Table
1. Add Button 2. Edit Button 3. Delete Button
3. Click Delete next to the chosen daemon.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.29.7
Managing Generic Tunnels
The Layer 2 Tunnel Daemon supports a generic mode of operation based on the Ethernet type of Layer 2 data
traffic seen by the router. Multiple tunnels may be configured, each one with:
• an Ethernet type
• a tunnel ingress (Ethernet interface)
• a tunnel egress (either another locally connected Ethernet interface, or the remote IP address of another Layer
2 Tunnel daemon instance running on another Router)
The following sections describe how to configure and manage generic tunnels:
• Section 5.29.7.1, “Viewing the Generic Tunnel Statistics”
• Section 5.29.7.2, “Viewing a List of Generic Tunnels”
• Section 5.29.7.3, “Adding a Generic Tunnel”
• Section 5.29.7.4, “Deleting a Generic Tunnel”
To Next Page
Loading...
