RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Managing Autonomous System Paths and Entries 457
1. Change the mode to Edit Private or Edit Exclusive.
2. Depending on the dynamic routing protocol being configured, navigate to routing » dynamic » bgp » filter »
{name} » entry, where {name} is the name of the prefix list. The Prefix List Entry table appears.
Figure 513: Prefix List Entry Table
1. Add Button 2. Edit Button 3. Delete Button
3. Click Delete next to the chosen entry.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.19.6
Managing Autonomous System Paths and Entries
The following sections describe how to configure and manage autonomous system paths and entries for dynamic
BGP routes:
• Section 5.19.6.1, “Viewing a List of Autonomous System Paths”
• Section 5.19.6.2, “Viewing a List of Autonomous System Path Entries”
• Section 5.19.6.3, “Adding an Autonomous System Path Filter”
• Section 5.19.6.4, “Adding an Autonomous System Path Filter Entry”
• Section 5.19.6.5, “Deleting an Autonomous System Path”
• Section 5.19.6.6, “Deleting an Autonomous System Path Filter Entry”
Section 5.19.6.1
Viewing a List of Autonomous System Paths
To view a list of autonomous system path filters for dynamic BGP routes, navigate to routing » dynamic » bgp »
filter » as-path. If filters have been configured, the Autonomous System Path Filter table appears.
To Next Page
Loading...
