Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
540 Deleting a Static Route
Figure 626: Key Settings Form
1. Subnet (Network/Prefix) Box 2. Add Button
3. Configure the following parameter(s) as required:
Parameter Description
Subnet (network/prefix) The subnet (network/mask) of the static route.
4. Click Add to add the route.
5. If necessary, configure either a gateway or an interface for the static route. Only one can be configured per
static route. For more informatoin, refer to Section 5.22.6.1, “Configuring Gateways for IPv6 Static Routes” or
Section 5.22.7.1, “Configuring Interfaces for IPv6 Static Routes”.
6. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
7. Click Exit Transaction or continue making changes.
Section 5.22.4
Deleting a Static Route
To delete a static route, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » static » {protocol}, where {protocol} is either IPv4 or IPv6. The Static Route table
appears.
To Next Page
Loading...
