Chapter 3
Device Management
RUGGEDCOM ROX II
User Guide
52 Deleting a Remote Server
Figure 43: Remote Server Form
1. Enabled Check Box
5. Configure the following parameter(s) as required:
Parameter Description
enabled Enables/disables the feed to the remote logging server.
6. Configure one or more selectors for the server. For more information, refer to Section 3.9.5.2, “Adding a
Remote Server Selector”.
7. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
8. Click Exit Transaction or continue making changes.
Section 3.9.4.3
Deleting a Remote Server
To delete a remote server, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to admin » logging » server. The Remote Server table appears.
Figure 44: Remote Server Table
1. Add Button 2. Edit Button 3. Delete Button
3. Click Delete next to the chosen remote server.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
To Next Page
Loading...
