Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
792 Managing IPv4 Addresses
Section 5.38.3
Managing IPv4 Addresses
The following sections describe how to configure and manage IPv4 addresses:
• Section 5.38.3.1, “Viewing a List of IPv4 Addresses”
• Section 5.38.3.2, “Adding an IPv4 Address”
• Section 5.38.3.3, “Deleting an IPv4 Address”
Section 5.38.3.1
Viewing a List of IPv4 Addresses
To view a list of IPv4 address for a routable interface, navigate to ip » {interface} » ipv4, where {interface} is the
name of the routable interface. If addresses have been configured, the Addresses table appears.
Figure 912: Addresses Table
If no addresses have been configured, add addresses as needed. For more information, refer to Section 5.38.3.2,
“Adding an IPv4 Address”.
Section 5.38.3.2
Adding an IPv4 Address
To add an IPv4 address to a routable interface, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to ip » {interface} » ipv4, where {interface} is the name of the routable interface.
3. Click <Add address>. The Key Settings form appears.
To Next Page
Loading...
