RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Configuring the DHCP Server 311
• Section 5.15.3, “Enabling/Disabling the DHCP Relay Support”
• Section 5.15.4, “Viewing a List of Active Leases”
• Section 5.15.5, “Managing DHCP Listen Interfaces”
• Section 5.15.6, “Managing Shared Networks”
• Section 5.15.7, “Managing Subnets”
• Section 5.15.8, “Managing Custom Client Options for Subnets”
• Section 5.15.9, “Managing Hosts”
• Section 5.15.10, “Managing Custom Host Client Configurations”
• Section 5.15.11, “Managing Host Groups”
• Section 5.15.12, “Managing Custom Host Group Client Configurations”
• Section 5.15.13, “Managing IP Pools”
• Section 5.15.14, “Managing IP Ranges for Subnets”
• Section 5.15.15, “Managing IP Ranges for IP Pools”
• Section 5.15.16, “Managing Option 82 Classes for IP Pools”
Section 5.15.1
Configuring the DHCP Server
To configure the DHCP server, do the following:
1. Enable the DHCP Server. For more information, refer to Section 5.15.2, “Enabling/Disabling the DHCP
Server”.
2. Add and configure DHCP listen interfaces. For more information, refer to Section 5.15.5.2, “Adding a DHCP
Listen Interface”.
3. Add and configure shared networks. For more information, refer to Section 5.15.6.2, “Adding a Shared
Network”.
NOTE
At least one shared network must be available before a subnet is added.
4. Add and configure subnets. For more information, refer to Section 5.15.7.2, “Adding a Subnet”.
5. Add and configure hosts. For more information, refer to Section 5.15.9.2, “Adding a Host”.
6. Add and configure host-groups. For more information, refer to Section 5.15.11.2, “Adding a Host Group”.
Section 5.15.2
Enabling/Disabling the DHCP Server
To enable or disable the DHCP server, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to services » dhcpserver. The Dynamic Host Control Protocol (DHCP) server form appears.
To Next Page
Loading...
