RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Deleting an IKE Algorithm 627
Figure 731: Key Settings Form
1. Cipher Algorithm Box 2. Hash Method Box 3. Mod Group Box 4. Add Button
4. Configure the following parameter(s) as required:
Parameter Description
Cipher Algorithm Synopsis: 3des, aes, aes256, aes192, aes128, any
The cipher algorithm. The default value is '3des' or 'aes' unless overwritten by the
default connection setting.
Hash Method Synopsis: sha1, md5, any
The hash method. The default value is 'sha1' or 'md5' unless overwritten by the default
connection setting.
Modpgroup Synopsis: modp1024, modp1536, modp2048, modp3072, modp4096, modp6144,
modp8192, any
The Modular Exponential (MODP) group. The default value is 'modp1024' or 'modp1536'
unless overwritten by the default connection setting.
5. Click Add to create the new algorithm.
6. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
7. Click Exit Transaction or continue making changes.
Section 5.28.7.3
Deleting an IKE Algorithm
To delete an algorithm for the Internet Key Exchange (IKE) protocol, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to tunnel » ipsec » connection » {connection} » ike, where {connection} is the name of the
connection. The Algorithm table appears.
To Next Page
Loading...
