RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Viewing a List of MPLS Interfaces 805
Parameter Description
MPLS Interfaces The interface that has been enabled for MPLS.
Status The operational status.
If no MPLS interface has been enabled, enable interfaces as needed. For more information about enabling MPLS
interfaces, refer to Section 5.39.4.3, “Enabling/Disabling an MPLS Interface”.
Section 5.39.4.2
Viewing a List of MPLS Interfaces
To view a list of MPLS interfaces, navigate to mpls » interface-mpls. If MPLS interfaces have been configured,
the MPLS Interface List Configuration table appears.
Figure 927: MPLS Interface List Configuration Table
If no MPLS interfaces have been configured, enable interfaces as needed. For more information about enabling
MPLS interfaces, refer to Section 5.39.4.3, “Enabling/Disabling an MPLS Interface”.
Section 5.39.4.3
Enabling/Disabling an MPLS Interface
To enable or disable an MPLS interface, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to mpls » interface-mpls » interface where interface is the name of the interface to enable or
disable for MPLS. The MPLS Interface List Configuration form appears.
Figure 928: MPLS Interface List Configuration Form
1. Enable Check Box
3. Configure the following parameter(s) as required:
To Next Page
Loading...
