Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
306 Deleting a GSM Profile
Parameter Description
The dial string given by the wireless provider to connect to the access point name.
sim Default: 1
Specify SIM index to be used by this profile
6. On the GSM PPP Configuration form, configure the following parameter(s) as required:
Parameter Description
use-peer-dns Enables the DNS server entries that the PPP server recommends. Enables this option
unless you provide your own name servers.
username Default: N/A
The user ID to connect to the remote server.
password Default: N/A
The password to be authenticated by the remote server.
dial-on-demand Activates dial-on-demand for this connection. The establishment of the PPP connection
is postponed until there is data to be transmitted via the interface. If dial-on-demand is
configured, Failover on Demand cannot be configured.
Prerequisite: If dial-on-demand is configured, Failover on Demand cannot be
configured.
disconnect-idle-timeout Default: 0
The time in seconds to wait before disconnecting PPP when there is no traffic on the
link. This option is only valid when dial-on-demand is enabled.
failover-on-demand Activates link failover on-demand on this device. PPP link establishment on this device
is controlled by link failover. If Failover on Demand is configured, Dial on Demand
cannot be configured.
Prerequisite: If link failover on-demand is configured, Dial on Demand cannot be
configured.
mtu Default: 1500
MTU (Maximum Transmission Unit) value on a PPP interface.
7. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
8. Click Exit Transaction or continue making changes.
Section 5.13.2.3
Deleting a GSM Profile
To delete a GSM Profile, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to global » cellular » profiles » gsm. The Cellular Network Configuration table appears.
To Next Page
Loading...
