RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Managing SNMP Communities 263
Section 5.11.5
Managing SNMP Communities
The following sections describe how to configure and manage SNMP communities:
• Section 5.11.5.1, “Viewing a List of SNMP Communities”
• Section 5.11.5.2, “Adding an SNMP Community”
• Section 5.11.5.3, “Deleting an SNMP Community”
Section 5.11.5.1
Viewing a List of SNMP Communities
To view a list of SNMP communities configured on the device, navigate to admin » snmp » snmp-community.
The SNMPv1/v2c Community Configuration table appears.
Figure 268: SNMPv1/v2c Community Configuration Table
By default, private and public communities are pre-configured. If additional communities are required, add them
as needed. For more information, refer to Section 5.11.5.2, “Adding an SNMP Community”.
Section 5.11.5.2
Adding an SNMP Community
To add an SNMP community, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to admin » snmp » snmp-community and click <Add snmp-community>. The Key Settings
form appears.
To Next Page
Loading...
