Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
590 Adding a VRRP Instance
If no VRRP instances have been configured, add instances as needed. For more information, refer to
Section 5.26.6.2, “Adding a VRRP Instance”.
Section 5.26.6.2
Adding a VRRP Instance
To add a VRRP instance, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Make sure a VRRP group has been configured. For more information, refer to Section 5.26.5.2, “Adding a
VRRP Group”.
3. Navigate to services » vrrp » instance and click <Add instance>. The Key Settings form appears.
Figure 686: Key Settings Form
1. Instance Name Box 2. Add Button
4. Configure the following parameter(s) as required:
Parameter Description
Instance Name The name of the VRRP instance - the name must not include spaces.
5. Click Add to add the instance. The VRRP Instance form appears.
To Next Page
Loading...
