RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Adding an Ingress Source Port 365
Figure 400: Ingress Source Ports Table
If no ingress source ports have been configured, add ingress source ports as needed. For more information, refer
to Section 5.16.3.2, “Adding an Ingress Source Port”.
Section 5.16.3.2
Adding an Ingress Source Port
To add an ingress source port for port mirroring, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to switch » port-mirroring » ingress-src and click <Add ingress-src>. The Key Settings form
appears.
Figure 401: Key Settings Form
1. Ingress Source Slot List 2. Add Button
3. Configure the following parameter(s) as required:
Parameter Description
Ingress Source Slot Synopsis: sm, lm1, lm2, lm3, lm4, lm5, lm6
The name of the module location provided on the silkscreen across the top of the
device.
Ingress Source Port The selected ports on the module installed in the indicated slot.
4. Click Add to create the new ingress source port.
5. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
6. Click Exit Transaction or continue making changes.
To Next Page
Loading...
