Chapter 4
System Administration
RUGGEDCOM ROX II
User Guide
192 Clearing Alarms
Section 4.6.2.1
Clearing Alarms
Non-conditional alarms must be cleared by the user. Conditional alarms, when configured, are cleared
automatically.
To clear a non-conditional alarm, do the following:
1. Navigate to admin » alarms » {alarm}, where {alarm} is the chosen alarm.
2. Click clear in the menu. The Trigger Action form appears.
Figure 203: Trigger Action Form
1. Perform Button
3. Click Perform to clear the alarm.
Section 4.6.2.2
Acknowledging Alarms
To acknowledge an alarm, do the following:
1. Navigate to admin » alarms » {alarm}, where {alarm} is the chosen alarm.
2. Click acknowledge in the menu. The Trigger Action form appears.
To Next Page
Loading...
