RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Deleting an IPv6 Address 801
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to ip » {interface} » ipv6 » adress, where {interface} is the name of the routable interface.
3. Click <Add address>. The Key Settings form appears.
Figure 922: Key Settings Form
1. Address Box 2. Add Button
4. Configure the following parameter(s) as required:
Parameter Description
IP Address The IPv6 address/prefix of this interface.
5. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
6. Click Exit Transaction or continue making changes.
Section 5.38.6.3
Deleting an IPv6 Address
To delete an IPv6 address for a routable interface, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to ip » {interface} » ipv6 » address, where {interface} is the name of the routable interface.
3. Click - symbol in the menu next to the chosen address.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.39
Managing MPLS
MPLS stands for Multi-Protocol Label Switching. MPLS operates between layer 2 and layer 3 of the OSI (Open
Systems Interconnection) model and it provides a mechanism to carry traffic for any network layer protocols.
MPLS makes forwarding decision based on labels where the labels are mapped to destination IP networks.
To Next Page
Loading...
