Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
288 Adding an NTP Server
Figure 298: Network Time Protocol (NTP) Servers Table
If no servers have been configured, add servers as needed. For more information, refer to Section 5.12.11.2,
“Adding an NTP Server”.
Section 5.12.11.2
Adding an NTP Server
To configure an NTP server on the device, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to services » time » ntp » server and click <Add server>. The Key Settings form appears.
Figure 299: Key Settings Form
1. NTP Server Box 2. Add Button
3. Configure the following parameter(s) as required:
Parameter Description
NTP Server Synopsis: The host type represents either an IP address or a DNS domain name.
The Internet address of the remote NTP server to be monitored.
4. Click Add to create the server configuration. The Network Time Protocol (NTP) Servers form appears.
To Next Page
Loading...
